Regular Article

Effect of heating rate of final annealing stage on secondary recrystallization in grain-oriented silicon steel

¹ School of Materials Science and Engineering, Inner Mongolia University of Technology, Hohhot 010000, PR China
² Inner Mongolia Key Laboratory of Thin Film and Coatings, School of Materials Science and Engineering, Inner Mongolia University of Technology, Hohhot 010051, PR China
³ Inner Mongolia Baotou Steel Union Co. Ltd., Baotou 014010, Inner Mongolia, PR China
⁴ State key Laboratory of Rolling and Automation, Shenyang 110819, PR China

^* e-mail: fanlifeng829@163.com

Received: 11 October 2019
Accepted: 1 September 2020

Abstract

A grain-oriented silicon steel sheet was manufactured by slab reheated at “medium temperature” and two-stage cold rolling method. The function of heating rate on secondary recrystallization in grain-oriented silicon steel was investigated. The results show that: compared with 30 °C/h heating rate, the initial temperature of the secondary recrystallization can increase by 10 °C at the heating rate of 20 °C/h. Furthermore, the temperature region of secondary recrystallization also extended either with the increased heating rate. Even though the inhibitors maintain AlN, complex precipitation of AlN and sulphide in both heating rate, the average diameter and Zener factor of inhibitors are distinct. Inhibitors in the route of 20 °C/h heating rate express stronger inhibition than that of 30 °C/h, and the average diameter and Zener factor are 17.519 nm and 3.925 × 10⁻⁴ nm⁻¹, respectively. In addition, more Goss texture component and less γ-fiber texture ({111}//ND) component form at the heating rate of 30 °C/h than 20 °C/h at 1000 °C, but the final Goss texture component of 20 °C/h is greater than 30 °C/h. The average grain size of the final annealing sheets increased with the heating rate decreasing from 30 °C/h to 20 °C/h, and iron loss reduced by 0.05 W/Kg, the magnetic induction intensity increased by 0.025 T.